MIT OpenCourseWare

Browse materialsMIT 2.996 · Fall 2007

Biomedical Devices Design Laboratory

Subjects: Engineering · Mechanical Engineering

Art: Department of State. Patent Office. (1836 - 1849), J.G. Hotchkiss' Patent Drawing for a Rotary Steam Engine - DPLA -…, 7 November… · Public domain

Instructor: Dr. Hongshen Ma
Term: Fall 2007
Level: Graduate
What's inside: 1 lecture note · 38 other files · 2 web pages
Materials open: MIT OCW

Start here

Start course: Lecture 1: Introduction ( PDF ) Robopsy slide ( PDF )Find a topic

Progress is saved in this browser.

Export or import progress

About this course

Source: MIT OpenCourseWare 2.996 Biomedical Devices Design Laboratory, Fall 2007, Dr. Hongshen Ma — original course page on ocw.mit.edu ↗. License: CC BY-NC-SA 4.0. Study order: MIT's own listing order, section by section. Taken from MIT's published course files, downloaded from ocw.mit.edu on September 23, 2026. How RedLectern is built.

Materials are grouped the way MIT organized them. A verified, course-wide order has not been established here.

Before you start

Prerequisites are not listed here. Check MIT's own syllabus for this course.

How this course was organized

What's here, and what isn't

A lecture sequence of 11 items is confirmed. No assignments or exams were found for this course, so it stays as organized materials rather than a full course order.

Not included here

1 item from the source could not be safely included:

MIT's page format for this item wasn't recognized clearly enough to place it safely.

Materials by section

Grouped by section, as MIT organized them. Not sequenced or ordered.

Lecture Notes

22 files

Labs

16 files

MIT OpenCourseWare, Dr. Hongshen Ma, 2.996 Biomedical Devices Design Laboratory, Fall 2007.

License: CC BY-NC-SA 4.0 · Edition: Fall 2007 · Open the original course on OCW ↗

Organized by RedLectern, independent of MIT and not endorsed by MIT.

Per-resource rights are recorded on each resource; All-Rights-Reserved items are link-only, never mirrored.

Biomedical Devices Design Laboratory

Before you start

What's here, and what isn't

Not included here

Materials by section

Lecture Notes

Labs

Lecture 1: Introduction ( PDF ) Robopsy slide ( PDF )

Lecture 2: Basic electronics Linear elements, thevenin-norton, impedance analysis ( PDF )

Lecture 3: Diodes and transistors Models, LEDs, peak-detector, zeners, diode protection circuits, BJT, FET, amplifiers, drivers, H-bridges ( PDF ) Handouts The Interactive Balloon ( PDF ) Balloons.mov ( MOV )

Lecture 4: Power supplies Proper bypassing, linear power supplies, switching power supplies ( PDF ) MIT libraries lectures on literature and patent searching

Lecture 5: Microprocessors I Basic topologies, feedback, stability, accurate peak detector ( PDF )

Lecture 6: Microprocessors II Practical considerations, reading op amp datasheets error propagation, filters ( PDF )

Lecture 8: OpAmps II Timers, communications, wireless ( PDF )

Lecture 9: Analog signal processing ADC, references, noise, synchronous detection ( PDF )

Lecture 10: Sensors I Capacitive, impedance, optical ( PDF )

Lecture 11: Sensors II Encoders, magnetic, strain acoustic, inertial